Yes, I use the Luckfox Lyra Ultra E with POE.
It is an amazing device that runs 10-15° cooler than my Pi3B+ that I tried before.
It uses <1W idle with the Ubuntu community image supplied also in the official doc.
The Pi3B+ was drawing 3W idle...
Generell würde ich, und mache es auch so, VPN und andere routen veränderte Dienste, immer in einer VM laufen lassen.
Darüber hinaus sind keine deiner realen Configs hier ersichtlich.
Und man benötigt Alles...
RAIDz1 is not the same (in performance/space behavior) as RAID5 and generally not a good fit for running VMs on: https://forum.proxmox.com/threads/fabu-can-i-use-zfs-raidz-for-my-vms.159923/
Hallo zusammen,
ich habe jetzt alles nochmal neu gemacht und 2 PVE Hosts inkl. QDevice (Raspi 4) in einem Cluster zusammen mit ZFS laufen. Seit einer Woche läuft alles wie es soll, fällt der eine Host aus, werden die LXCs und die...
Ich habe nur eine Frage gestellt, die sich nun erübrigt hat, da du geantwortet hast. Ich entschuldige mich, dir evtl. auf die Füsse getreten zu sein. So bleibt also nur Willkommen.
Danke! Ich bin auf jeden Fall echt und relativ neu bei Proxmox. Als Privatanwender ist die Lernkurve zeitweise echt steil, und bei einigen Beiträgen weiter oben konnte ich den Frust körperlich spüren. Daher etwas contribution meienrseits...
Keine Storagebox benutzen, da PBS nicht dafür entwickelt wurde, Storage über Netzwerkfreigaben anzubinden:
https://forum.proxmox.com/threads/datastore-performance-tester-for-pbs.148694/
Im lokalen Netzwerk ist das schon nicht geil ( siehe...
Don't panic! ;-)
Etwas ungewöhnlich ist ein "first post" als Antwort auf einen ziemlich alten Post eigentlich schon, oder?
In den letzten ~12 Monaten gab es allerdings auffallend viele davon. Und vermutlich häufig von Bots bzw. per Script mit...
Hi!
In case of a fenced node, the HA resources on the fenced node are put in recovery state and the HA Manager will select a recovery node for each HA resource individually. This will always try to spread the HA resources on the remaining...
You need to enable 'Thin provision' for your Storage in in Proxmox. This only applies to new virtual disks but you can fix this for existing ZFS manually. See this thread for example...
Das kam jetzt offenbar etwas unpassend 'rüber, sorry. Mein obiger Blumentopf war nur als Spitze gegen den nicht zitierten Teil:
"Ohne schnellen und zuverlässigem shared storage, kannst du bzgl. HA keinen Blumentopf gewinnen. Hier wird es aber...
In unserem seit ~3 Jahren bestehendem 5-node cluster zzgl. 1 (rocky9) nfs-server sind so ziemlich alle pve's hier und da mal durchgefenct worden, den nfs-server hat's noch nie zerlegt - insofern ist in der realen Welt das cluster mit den...
Eben nicht. Wenn man Storage-Replikation aktiv hat UND HA für die entsprechende VM aktiviert, dann wird die VM auf den anderen Knoten weitegeführt auf Basis des letzten Replikationsstandes. Ja, das ist keine echte Hochverfügbarkeit und hat einen...
Ja, gut erkannt :)
Und mit NFS kannst du bzgl. HA keinen Blumentopf gewinnen. Jedenfalls nicht, solange der NFS ein Spof ist und die gesamte Netzwerkinfrastruktur nicht ebenfalls redundant ausgelegt ist.
Jedes Konstrukt, welches im Homelab...
Ich empfehle das für dein individuelles Setup zu testen. Ich würde mal mit iotop-c -cPa beginnen (mit delayacct booten), das ne halbe Stunde laufen lassen, nach DISK WRITE sortieren (Arrow Key) und dann hier ein Bild davon teilen.
Doch schon, nur dann halt mit maximal SATA-Performance. Das finde ich im Homelab vertretbar, vor allen weil typische Consumer-NVMEs ohne Powerloss-Protection ja auch nicht unbedingt die beste Performance haben. Dieser Mirror wird dann halt...
Not sure if you know the following...:
Move the mouse pointer over the graph. A hint / tooltip will be shown to tell you the exact value of a near-by point.
You can also zoom into the left bottom to see the small peak.