Recent content by falves1

yes, thanks

there is an update that takes systemd to version 234, and that works fine with pve 8. So the template should be there. Please google the update. it's in epel.

I did this and the templates are very limited. For instance, no Centos 8 Stream and 7. Many times I need to add those old versions because some apps require them.

Since I upgraded to Promox 8, I cannot install the packages lxc-templates apt -y install lxc-templates Reading package lists... Done Building dependency tree... Done Reading state information... Done Some packages could not be installed. This may mean that you have requested an impossible...

I installed kernel 6.2 as instructed and when it came back, it did not find the pve group, so it would not boot. I had to do a reset and boot in 6.1.15-1, and it came back. Do you have any idea what's happening? how do I remove kernel 6.2? I did the upgrade because every two weeks I have a...

I have several Proxmox 7.1 servers in different cities. I want to emulate what we do with Vmware and move VMs and Containers or close across servers. Is this possible? It's not a cluster since they are located far apart. Yours Philip

I still don't know how to proceed. This is a container with a new OS, Ubuntu 20.04, how do I make it work "normally"?

I created a container, Ubuntu 20.04, and it finishes fine, but it never starts, it stays forever in the picture below. This is a new machine and this is its first container Where do I go from here? The Start button fails and the consoles don't work. Proxmox thinks is not started, but it's...

Are there updated instructions for a command-line installation of Proxmox 7 over Debian 11? This is an example for older versions of Proxmox: https://pve.proxmox.com/wiki/Install_Proxmox_VE_on_Debian_Jessie

I read the link but I cannot figure out how to permanently enable network type="macvlan" and "phys". Proxmox should support these networks in the GUI, not as a hack. There are good reasons to expand network support: the developers just said, last week, that macvlan is faster then veth. In the...

a) I need to assign a physical network interface to a container, with type=phys, how do I enable this? I did it manually and it works but the config file gets regenerated after restarting the container. Is there a way to avoid this? I added lxc.net.0.type = phys lxc.net.0.name = eth0...

I have the same issue in the latest version. The space under /dev/pve/data is not visible. If I mount it in /etc/fstab, it fails to boot, it stops and asks for the root password for maintenance. so how do I use Proxmox and also use the data wasted under /dev/pve/data? Ths should be usable and...

Network Manager makes RHEL 8 and Centos 8 impossible to containerize. Please see that it detects a device type macvlan, when it should be really Ethernet. nmcli connection up Ethernet0 Error: Connection activation failed: No suitable device found for this connection (device lo not available...

the question is how I get my installation back up, and how I make sure that my /dev/pve/data is visible from Debian, to be used to other purposes. In fact, if you install a fresh machine with 6.1, the data device is not mounted on Debian, and we need the space for general server purposes. You...

whatever was there was deleted by debian when when I did an full upgrade. cat /etc/apt/sources.list.d/* cat: '/etc/apt/sources.list.d/*': No such file or directory