Recent content by elmacus

Testing Windows Server 2012, every time big incremental size: using fast incremental mode (dirty-bitmap), 266.1 GiB dirty of 328.0 GiB total ------ backup was done incrementally, reused 301.62 GiB (91%) transferred 266.07 GiB in 1679 seconds (162.3 MiB/s) Daily optimize on C-disc is on. But i...

Well, this turned off telemetry and silenced the gui err: ceph mgr module disable telemetry Still why it fails i dont know, i will not activate telemetry again until i understand why it failed.

Yes, that is their docs, thanks. Been there, doesnt help me. ceph telemetry off, does not work. Proxmox gui says big red warning: HEALTH_ERR Well, this turned off telemetry and silenced the gui err: ceph mgr module disable telemetry

Hi. I got Health_Err in gui for telemetry.ceph.com: #ceph telemetry off Error EIO: Module 'telemetry' has experienced an error and cannot handle commands: HTTPSConnectionPool(host='telemetry.ceph.com', port=443): Max retries exceeded with url: /report (Caused by...

Thanks Tom, exactly what i was looking for. Wolfgang did not mention this. This info need to be in the documentation: 8.5 Directory Backend.

Reinstall fixed and made it possible to add to cluster. Gui "bug" is probably still there, but i will not try that again on this server, now in production. The uuid was also looked (but failed since disk was reinstalled) for at boot, so maybe its a systemd thing ?

Hi I have same issue, Newly OSD for /dev/sdc became also LVM and is named "Ceph osd.xx (BLuestore)" But only /dev/nvme0n1 is named "LVM" So its clearly possible to fix this bug ?

Thanks for answer. Well in that case its a bug in GUI since its not in /etc/pve/storage.cfg, i did create the directory in GUI. Not hardcoded. But now when adding this server to the production cluster, it failed for unknown cause (corosync i guess, no log, in syslog: pveproxy[11952]...

Hi. After testing some new disk with ext and xfs, i end up with a Server/Disks/Directory with "/mnt/pve/test-disk /dev/disk/by-uuid/xxxxxx ext4 defaults" This disk in now gone/formatted and replaced with xfs manually. But this line in gui i cant find out how to remove. (its not in...

Yep that was it: --> ceph-volume lvm create successful for: /dev/nvme0n1 Thanks for GREAT support, you should add this info about ceph.conf to the wiki.

Thanks. And .151 is any server in ceph cluster ? Is there a commando to check the net now before i add? So i dont set it to wrong nets.

I have installed ceph in Proxmox 5 and upgraded to 6, always following wiki and forum, i dont know where it supposed to be ? Anyway it must be on x.x.0.0. Show me your ceph.conf

Yes ceph is working, its the same net at the moment, im trying to split them in future, thats why i have created new net. # ip address 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet...

Yes, its a production ceph. I did remove the extra net to test, but that did not help.

Smartmontools not working for Samsung Enterprise SSD SAS PM1643 for wearout. I wonder if smartmontools 7.1 that is in Bullseye do work for these ? Is it possible for Proxmox to backport ? I only get this from smartctl -a: === START OF READ SMART DATA SECTION === SMART Health Status: OK...