eth1 for host and one ct

I

informant

Renowned Member
Jan 31, 2012
816
11
83
Hi, we have on eth1 a internal network. this we use for storages. what do we must do to have access with a special linux ct to this 2nd network? I hope, you have a solution for us. Very thanks.

regards
 
Hi udo,

can i set access only to one or two ct´s? or it´s the access for all ct´s and vm´s?

regards
 
informant said:
Hi udo,

can i set access only to one or two ct´s? or it´s the access for all ct´s and vm´s?

regards
Click to expand...
Hi,
access have only the CTs/VMs which have an bridged interface in this vlan (mean on this bridge).
You can look with brctl which machines are connected:
Code: 
brctl show
bridge name     bridge id               STP enabled     interfaces
vmbr0           8000.000f53073c90       no              eth0
vmbr10          8000.000f53073c91       no              eth1.10
                                                        tap203i0
                                                        tap205i2
                                                        tap212i0
                                                        veth232.0
vmbr300         8000.000f53073c91       no              eth1.300
                                                        tap220i1
Udo
 
Hi udo,

thanks for reply.

We have configured a new bridge with

name: vmbr1
autostart: yes
ip: local ip
subnetz: our subnetz
gateway: none

if we restart the network service we get the message:
Ignoring unknown interface eth1=eth1.

But before we have used eth1 normal with internal ip.

Do you have a idea?

regards

solution: we must restart complete server, after this its works. very thanks
 
Last edited:
You must log in or register to reply here.
Top Bottom