Kleiner Übersetzungsfehler zwischen euch: mit "Rechenzentrum" meint @AlexanderB glaub ich die Datacenter-Ansicht im PVE-Webinterface, nicht ein echtes RZ. Also nein, PVE ist unter Storage nur Client, es kann SMB/NFS-Shares einbinden, aber selbst...
Wir arbeiten bei einem Großteil unserer Server mit DHCP. Am Standort B ist für alle zu migrierenden VMs bereits ein DHCP -Eintrag für das entsprechende Netz vorhanden. Sollte ein neuer Server dazu kommen, muss dies eben gepflegt werden. Aber das...
Verschleiß bei gebrauchten Optane kannst du auslesen, nvme smart-log /dev/nvme0 zeigt dir Percentage Used und Data Units Written. Bei den Dingern steht das fast immer noch bei 0-1%, die Endurance ist so hoch dass du sie als Special Device...
Was mir im Thread noch fehlt, ist das Netz. Wenn du die Disks 1:1 replizierst, kommt die VM in B mit ihrer Config aus A hoch, also gleiche IP, gleiche MAC. Entweder ziehst du die betroffenen VLANs nach B durch, oder du brauchst pro VM eine zweite...
You are right, for corosync the recommendation is to have latancy below 5ms.
I would not activate HA in such setup because it might lead to a lot of fences (reboot).
Was mir im Thread noch fehlt, ist das Netz. Wenn du die Disks 1:1 replizierst, kommt die VM in B mit ihrer Config aus A hoch, also gleiche IP, gleiche MAC. Entweder ziehst du die betroffenen VLANs nach B durch, oder du brauchst pro VM eine zweite...
Based on your screenshot, the Proxmox web interface is loading the page, but the JavaScript required for the login screen isn't loading correctly. I also noticed a 500 error for /PVE/StdWorkspace.js and JavaScript errors like "c is not a...
See `Can I mix x86-64 and arm64 nodes in one cluster?` in the Q&A section, I assume to get around the different arch problem, you could use Affinity Rules to let VMs only HA between same architecture.
Have no idea what this switch supports, no one does except OVH staff. What I use for this setup is OVH dedicated servers hosted somewhere https://eco.ovhcloud.com/en-gb/rise/rise-3/ and what they call vRack...
I am trying to setup a backup location on a remote nfs server. When I go to setup the nfs storage via the datacenter, it goes through and sets up the storage.
storage.cfg snippet
nfs: nfs-backup
export /home
path...
FWIW 7.0.14-8-pve works and boots just fine for me. Asrock WRX80 Creator R2.0 and 4x1TB Corsair MP600 Pro LPX NVME on an Asus Hyper M.2 Gen4 card (x4x4x4x4, passive card)
E: also works with the latest 7.0.14-11-pve
E2: I am using systemd-boot...
daan, UdoB, and J-Rod
Thanks for the advice. I did try to use the offline repo method but after 3 days of fighting with setting up the Repo and pgp keys I finally gave up. Keys were a pain in the you know what.
I did get the upgrade done. My...
hi @MKIe I have something similar but my issue seems to be after a while the same emails start to go through again. How good is the setup you done.
Thank you again for your support.
rajbps
I may have the same issue. With the 7.0.14-8 kernel, I am unable to boot a couple Supermicro SYS-E300-12D-10CN6P machines using bifurcation with AOC-SLG3-2M2 splitter cards (no active switch chips) and NVMe SSDs. I have 7.0.14-6 pinned until I...
Yes... I did originally want to use that storage as a temporary measure while I was sorting other things out. Selecting it for this particular VM was not intended!
Agreed, but I'm not sure much useful has been lost there. At the time of the...