Thanks you all for the fast comments.
I could not start a snapshot in the GUI, the button "Take snapshot" was greyed out every time i tried.
The problem was, as often, sitting in front of the keyboard.... and now i feel really bad.
I just...
The license of Proxmox VE is always the same, primarily the AGPv3. We do sell subscriptions ;)
There are no differences in limitations or features, no matter if a subscription is applied or not. Once you use it in production, subscriptions are...
Could someone please clarify the limitations associated with utilizing Proxmox in a test lab environment without a license?
I would appreciate insights on the following aspects:
1. Limitations virtual machines (VMs)
2. Limitations concerning...
Hi,
@aaron already mentioned that there is no limitation. This does not depend on whether you have a subscription or not.
For a tongue-in-cheek answer: a guest ID is a number between 100 and 999999999, so you can create up to 999999899 guests...
Hey,
das NO-CARRIER bedeutet, dass kein physischer link bei eno1 erkannt wird. Meistens ist das Kabel nicht ordentlich eingesteckt, oder defekt. Hast du das schon überprüft?
Hi @fiona,
unfortunately i had no success with rebooting or shutdown and start the VM using the UI!
Still the same warning about 'EFI disk without 'ms-cert=2023k' option,'.
Looks like the marker is not applied.
Stopping the VM and manually...
Thanks for the response.
There are no proxies and the server is whitelisted in firewall . The logs in systemd show only the following
May 13 02:33:41 pbs0 proxmox-backup-proxy[137566]: TASK ERROR: error reading a body from connection...
MSehr gut. Ich hatte es schon gesehen, aber die Titel „Installation“ und „Konfiguration“ passten nicht zu meinem „Problem“. Danke und viel Erfolg an alle.
hi, in https://pve.proxmox.com/wiki/Cluster_Manager#_corosync_external_vote_support
Unlike corosync itself, a QDevice connects to the cluster over TCP/IP. The daemon can also run outside the LAN of the cluster and isn’t limited to the low...
Sorry for the mixup! those posts were created yesterday but i didn't see them in my feed. Today morning i checked the forum again to ensure that these posts are not visible before creating a new one.
yes, please open a new thread (feel free to mention @ me) and include a journal of the working kernel and details about your setup and hardware, in particular where your rootfs is stored ;)
It seems that there is a race condition regarding systemd-tmpfiles and several ZFS related services. We are using ZFS on LUKS and a systemd service to unlock the LUKS partitions. Curiously this didn't happened before. I'll try to fix this.
As discussed on the 7.0 kernel thread, I'm opening a new thread to investigate the issue.
Yesterday I updated pve from 9.1.6 to 9.1.9, which installed a 7.0.x kernel. However on reboot I got a Kernel Panic :
unable to mount root fs on...
The PBS is a standalone machine and according to the statistics page (see image below), there are no memory constraints. The s3 garbage collect runs at 2:30 everyday and here is the system summary from the Server administration page. Both cpu and...
Hi @r.wegmann,
the second orange line just means that the change cannot be applied immediately while the VM is running. It will be applied the next time, the VM is started or rebooted from the UI (reboot within the VM is not enough). If the...
Hi, i´m having the same behaviour on my machine:
Lenove ThinkCentre 715
64 GB RAM
When running kernel Linux 6.8.12-13-pve it absolutely runs smooth, when booting into any other kernel the system freezes after some minutes or ours.
so what was...
We have an issue: the data transfer rate during sync job is extremely slow, 20-50 MB/s.
The hard drives used are a 3.5" Toshiba MG10-F 22 TB MG10SFA22TE SAS 12Gb/s hard drive.
Connected via a 12Gb/s HBA
There is no load on them during the data...