To be able to install packages from this component, run editor /etc/apt/sources.list, append non-free-firmware to the end of each .debian.org repository line and run apt update.
The plugin does support snapshots? To what are you refering too?
Feature Comparison
FeatureTrueNAS PluginStandard iSCSINFS
Snapshots✅⚠️⚠️
VM State Snapshots (vmstate)✅✅✅
Clones✅⚠️⚠️
Thin Provisioning✅⚠️⚠️
Block-Level Performance✅✅❌...
I've just installed proxmox on a new NVME SSD and under /lib/modules the only subdirectories are:
6.17.2-1-pve & 6.17.4-1-pve.
When I run uname -a the result is:
Linux pve 6.14.8-2-pve #1 SMP PREEMPT_DYNAMIC PMX 6.14.8-2 (2025-07-22T10:04Z)...
Hi,
danke euch!
Ne, ich baue ja keinen Cluster :)
Über Port 8007 dürfen explizit nur die IPs der Backup-Server rein, und so wie ich verstanden hatte, geht ein Pull-Job nur von einem PBS zum anderen, aber nicht von einem Proxmox zum PBS. Ist...
pay attention to your bond stanza.
If you're trying to connect it to a lagg, use the lacp config. If you're connecting to access ports, use the active/backup configuration.
In either case, your switch should have a flow analysis tool (I dont...
So, nun Murphys Law:
Die 2x neuen PLP SSDs laufen in meinem alten Asus Board beide (Core 6.Gen),
in meinem MSI Board (Core 12.Gen) lässt sich nur eine nutzen.
Soviel zum Thema Technik Standards :rolleyes:
Das hat jetzt mit "GELD" erst einmal nichts zu tun, da die genannten Programme OpenSource sind.
Aber es gibt durchaus interessante Alternativen, zum einen kannst du von Veeam eine kostenfreie 10 Workload Version bekommen und das mit dem Agenten...
Das hat jetzt mit "GELD" erst einmal nichts zu tun, da die genannten Programme OpenSource sind.
Aber es gibt durchaus interessante Alternativen, zum einen kannst du von Veeam eine kostenfreie 10 Workload Version bekommen und das mit dem Agenten...
I tried the 'update' to the interfaces and it didn't work. no ip connectivity anywhere, except itself.
I have created a port trunk on my fortigate switch, configured as 'active/active'. I tried with 'default vlan' of 100 and no default with...
I had not checked that status and I moved all of my VMs to an NFS share on the same box... (I had a hardware issue to resolve, used = unstable :D ) no issues since... now that I have repaired all the HDWare issues. I will go back to testing...
Will share once I reach home. The forwarding was configured in my troubleshooting. it was disabled. I believe exit nodes are not declared, the north/south setup was manual via frr+BGP.