pay attention to your bond stanza.
If you're trying to connect it to a lagg, use the lacp config. If you're connecting to access ports, use the active/backup configuration.
In either case, your switch should have a flow analysis tool (I dont...
So, nun Murphys Law:
Die 2x neuen PLP SSDs laufen in meinem alten Asus Board beide (Core 6.Gen),
in meinem MSI Board (Core 12.Gen) lässt sich nur eine nutzen.
Soviel zum Thema Technik Standards :rolleyes:
Das hat jetzt mit "GELD" erst einmal nichts zu tun, da die genannten Programme OpenSource sind.
Aber es gibt durchaus interessante Alternativen, zum einen kannst du von Veeam eine kostenfreie 10 Workload Version bekommen und das mit dem Agenten...
Das hat jetzt mit "GELD" erst einmal nichts zu tun, da die genannten Programme OpenSource sind.
Aber es gibt durchaus interessante Alternativen, zum einen kannst du von Veeam eine kostenfreie 10 Workload Version bekommen und das mit dem Agenten...
I tried the 'update' to the interfaces and it didn't work. no ip connectivity anywhere, except itself.
I have created a port trunk on my fortigate switch, configured as 'active/active'. I tried with 'default vlan' of 100 and no default with...
I had not checked that status and I moved all of my VMs to an NFS share on the same box... (I had a hardware issue to resolve, used = unstable :D ) no issues since... now that I have repaired all the HDWare issues. I will go back to testing...
Will share once I reach home. The forwarding was configured in my troubleshooting. it was disabled. I believe exit nodes are not declared, the north/south setup was manual via frr+BGP.
When needing to set up a thinpool over LVM RAID1, these 4 liners have always worked for me.
pvcreate /sda5 /sdb5
vgcreate vg-b /dev/sda5 /dev/sdb5
lvcreate --type raid1 -m 1 -l 97%FREE -n proxthin vg-b
lvconvert --type thin-pool...
The problem is that PVE is meant to be flexible and used with various methods of storage. I tend to agree that the zfs and disk sections ought to be combined into one, but for my use case I dont use ANY of those at all as my storage is either...
Hallo Forum,
ich nutze Proxmox jetzt seit knapp einem Jahr und bin wirklich begeistert. Debian verwende ich seit etwa 15 Jahren. Die aktuelle Proxmox-Installation habe ich auf mein bestehendes Debian 12 aufgesetzt.
Nun steht das Update von...
Habe jetzt neun neue Festplatten verwendet jetzt drei OSD pro Node.
Write und Read ist jetzt noch besser im Ceph Benchmark aber in der Windows Umgebung nicht Spürbar werte sind dort gleich. Ist es echt so das ich mit drei Nodes diese Performance...