ZFS Pool detail error in gui after upgrade
- Thread starter m3a2r1
- Start date
You can always use
A rollback can be ony be done if your pool wasn't updated already.
BTW:
I see the same error, but only on a newly created zpool, which is connected via USB as a backup medium.
My internal pools that were upgraded to 2.0.3, do not show this problem.
zpool status on the command line in the terminal.A rollback can be ony be done if your pool wasn't updated already.
BTW:
I see the same error, but only on a newly created zpool, which is connected via USB as a backup medium.
My internal pools that were upgraded to 2.0.3, do not show this problem.
I wonder if it has something to do with zfs scrub, since I have not run a scrub on the new pool yet, and I can't at the moment, since the pool is very busy.
EDIT: I just started a scrub and the error message is gone.
EDIT: I just started a scrub and the error message is gone.
Last edited:
I just double checked: The old version reported:
scan: none requested While in the new version the scan line is missing, when no scrub was performed. So this is a minor GUI bug.You're right. I've tested on fresh install without scrub. When I scrub zfs pool, that error disappears.
But after scrub I've got this:
when I'm trying upgrade:
But after scrub I've got this:
Code:
status: Some supported features are not enabled on the pool. The pool can
still be used, but some features are unavailable.
action: Enable all features using 'zpool upgrade'. Once this is done,
the pool may no longer be accessible by software that does not support
the features. See zpool-features(5) for details.when I'm trying upgrade:
Code:
cannot set property for 'rpool': invalid feature 'redaction_bookmarks'