VLAN Configuration Sync Across Proxmox Cluster Nodes

[lover]

Hello everyone!

I'm currently exploring Proxmox and wondering if there's a feature akin to VMware's vSphere Distributed Switch. I've configured my setup on one node, as shown below, and now aim to replicate this configuration across other nodes in my cluster, particularly the VLANS on vmbr1. While I've tinkered with open vSwitch, I'm starting to believe that I might need to utilize SDN. However, I'm encountering difficulties in fully understanding how to use it. Any guidance or suggestions would be highly appreciated!

Thank you

 

[spirit]

the only way to do it like vmware distributed vswitch is to use sdn vlan zone, then create 1vnet for each vlan.

The other way is to define tag in vm nic directly.

(you don't need to define ip address for each vlan to get network for your vms, it's only used for host management ips)

 

[lover]

the only way to do it like vmware distributed vswitch is to use sdn vlan zone, then create 1vnet for each vlan.

The other way is to define tag in vm nic directly.

(you don't need to define ip address for each vlan to get network for your vms, it's only used for host management ips)

Thank you for your reply spirit! I created a VLAN zone and set the bridge to vmbr1 then added a vnet for each vlan tag. So would I still have to touch each node and create the vmbr1 bridge?

Thanks!