Vlan Aware Linux Bridges

[marcm1992]

Hello everyone, fairly new to Proxmox so I hope this isn't an obvious question I'm asking.

I'm attempting to build a lab which would require Vlans on two separate bridges. Neither bridge is connected to the physical NIC.
The first bridge works fine, the bridge is active and it is Vlan Aware. I am able to also route between Vlans.
The problem is the second bridge, if I make the bridge Vlan Awaryre, it is not active. But I am able to activate the bridge if it is not Vlan aware.

Is there a limit to the number of Vlan aware bridges I can create or am I doing something wrong?

Thanks in advance, this forum has been very helpful in helping me work out small issues I find on Proxmox.

 

[Moayad]

Hi,

Can you share your network configurations?

cat /etc/network/interfaces

Please post the network config between codes [ICODE ][ /ICODE]

 

[marcm1992]

the problem in vmb102
[
auto lo
iface lo inet loopback

iface eno1 inet manual

auto vmbr0
iface vmbr0 inet static
address 172.16.0.1
netmask 255.255.255.0
gateway 172.16.0.254
bridge-ports eno1
bridge-stp off
bridge-fd 0

auto vmbr101
iface vmbr101 inet static
address 10.101.0.0
netmask 16
bridge-ports none
bridge-stp off
bridge-fd 0
bridge-vlan-aware yes
bridge-vids 2-4094
#Maryland Office Switch

auto vmbr102
iface vmbr102 inet manual
bridge-ports none
bridge-stp off
bridge-fd 0
bridge-vlan-aware yes
bridge-vids 2-4094

auto vmbr150
iface vmbr150 inet manual
bridge-ports none
bridge-stp off
bridge-fd 0
#WAN]