VLAN Aware Bond?

[roomwillow]

I'm new to ProxMox so excuse if I'm misunderstanding, I created a bond of eno2, eno3, eno4, (bond0) in LACP mode, it's listed as not vlan aware, and I have a windows 10 VM attached to vmbr1 which is using bond0 as its port, the VM interface is tagged 400, and is unable to ping anything on the switch, I double checked and eno2-4 on the switch is a LAG in LACP mode, so I'm not sure whats really wrong, the bond not being vlan aware is my best guess, anything in particular I should be looking for?

Thanks!

 

[spirit]

vlan-aware option is for the bridge, not the bond. Bond interfaces like ethX interfaces transport vlan without any problem.

You can also use vlan with a bridge without vlan-aware option, it's working too. (in this case, proxmox create in background a new vmbrXv(vlanid) bridge with ethx.Y interface)


Don't known what is not working for you, but it's not related to bond-vlan.

do you have tried first without any bonding ?

 

[roomwillow]

vlan-aware option is for the bridge, not the bond. Bond interfaces like ethX interfaces transport vlan without any problem.

You can also use vlan with a bridge without vlan-aware option, it's working too. (in this case, proxmox create in background a new vmbrXv(vlanid) bridge with ethx.Y interface)


Don't known what is not working for you, but it's not related to bond-vlan.

do you have tried first without any bonding ?

I was doing this while I was tired last night, turns out i left the LAG group on the switch set to access instead of trunk, and had the wrong pvid, fixed that and it started working right away.

Thanks!