USB pass trough with equal vendor and device ID

Discussion in 'Proxmox VE: Installation and configuration' started by zebra, Feb 13, 2014.

  1. zebra

    zebra New Member

    Joined:
    Feb 13, 2014
    Messages:
    1
    Likes Received:
    0
    Running v3.1 with an Win8.1 VM

    info usbhost in monitor gives:

    Bus 2, Addr 15, Port 1.5.6, Speed 12 Mb/s
    Class 00: USB device 10c4:ea60, CP2102 USB to UART Bridge Controller
    Bus 2, Addr 17, Port 1.5.4, Speed 12 Mb/s
    Class 00: USB device 10c4:ea60, CP2102 USB to UART Bridge Controller


    As you can see, the two device have the same vendor/device ID


    Normally I use: device_add usb-host,id=usb1,vendorid=0x0403,productid=0x6001
    that works for the other devices I use but now I am lost.
    I have also tried: device_add usb-host,hostbus=2,hostport=1.5.6 but had no luck


    On a side note: every restart of the VM I have to add them again. Wish I could make these settings last.


    Any tips?




     
  2. p3x-749

    p3x-749 Member

    Joined:
    Jan 19, 2010
    Messages:
    103
    Likes Received:
    0
    #2 p3x-749, Feb 13, 2014
    Last edited: Feb 13, 2014
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice