unseen jbod drives

[ravdrak]

hi there

just newly installed to my old thinksystem ST250 with 530-8i raid controller card. i set to jbod on lenovo system the pbs wont seen any drives? thanks

root@pbs:~# dmesg | grep -iE "sas|sata|sd|ahci"
[ 0.007595] ACPI: RSDP 0x000000008DD53000 000024 (v02 LENOVO)
[ 0.007599] ACPI: XSDT 0x000000008DD530D0 000124 (v01 LENOVO THINKSYS 00000100 AMI 00010013)
[ 0.007609] ACPI: DSDT 0x000000008DD53288 03BAA1 (v02 LENOVO THINKSYS 00000100 INTL 20160527)
[ 0.007630] ACPI: SSDT 0x000000008DD8F030 001B1C (v02 CpuRef CpuSsdt 00003000 INTL 20160527)
[ 0.007636] ACPI: SSDT 0x000000008DD90B80 0031C6 (v02 SaSsdt SaSsdt 00003000 INTL 20160527)
[ 0.007639] ACPI: SSDT 0x000000008DD93D48 00232B (v02 PegSsd PegSsdt 00001000 INTL 20160527)
[ 0.007645] ACPI: SSDT 0x000000008DD960B0 000FAE (v02 LENOVO Ther_Rvp 00001000 INTL 20160527)
[ 0.007648] ACPI: SSDT 0x000000008DD97060 0008F4 (v02 INTEL xh_mossb 00000000 INTL 20160527)
[ 0.007654] ACPI: SSDT 0x000000008DD979A0 0003A2 (v02 LENOVO THINKSYS 00001000 INTL 20160527)
[ 0.007659] ACPI: SSDT 0x000000008DD97DE0 0027DE (v02 LENOVO PtidDevc 00001000 INTL 20160527)
[ 0.007662] ACPI: SSDT 0x000000008DD9A5C0 0014E2 (v02 LENOVO TbtTypeC 00000000 INTL 20160527)
[ 0.007671] ACPI: SSDT 0x000000008DD9BB38 001B67 (v02 LENOVO UsbCTabl 00001000 INTL 20160527)
[ 0.007680] ACPI: SSDT 0x000000008DD9D888 000144 (v02 Intel ADebTabl 00001000 INTL 20160527)
[ 0.007682] ACPI: UEFI 0x000000008DD9D9D0 00005C (v01 INTEL RstSataV 00000000 00000000)
[ 0.007685] ACPI: SSDT 0x000000008DD9DA30 000D8F (v02 INTEL SpsNm 00000002 INTL 20160527)
[ 0.007688] ACPI: SSDT 0x000000008DD9E7C0 00021F (v02 LENOVO CDNTABLE 00001000 INTL 20160527)
[ 0.007706] ACPI: Reserving DSDT table memory at [mem 0x8dd53288-0x8dd8ed28]
[ 0.007712] ACPI: Reserving SSDT table memory at [mem 0x8dd8f030-0x8dd90b4b]
[ 0.007713] ACPI: Reserving SSDT table memory at [mem 0x8dd90b80-0x8dd93d45]
[ 0.007714] ACPI: Reserving SSDT table memory at [mem 0x8dd93d48-0x8dd96072]
[ 0.007716] ACPI: Reserving SSDT table memory at [mem 0x8dd960b0-0x8dd9705d]
[ 0.007716] ACPI: Reserving SSDT table memory at [mem 0x8dd97060-0x8dd97953]
[ 0.007718] ACPI: Reserving SSDT table memory at [mem 0x8dd979a0-0x8dd97d41]
[ 0.007720] ACPI: Reserving SSDT table memory at [mem 0x8dd97de0-0x8dd9a5bd]
[ 0.007720] ACPI: Reserving SSDT table memory at [mem 0x8dd9a5c0-0x8dd9baa1]
[ 0.007723] ACPI: Reserving SSDT table memory at [mem 0x8dd9bb38-0x8dd9d69e]
[ 0.007725] ACPI: Reserving SSDT table memory at [mem 0x8dd9d888-0x8dd9d9cb]
[ 0.007727] ACPI: Reserving SSDT table memory at [mem 0x8dd9da30-0x8dd9e7be]
[ 0.007727] ACPI: Reserving SSDT table memory at [mem 0x8dd9e7c0-0x8dd9e9de]
[ 0.339462] ACPI: SSDT 0xFFFF89FB8080A400 000400 (v02 PmRef Cpu0Cst 00003001 INTL 20160527)
[ 0.341090] ACPI: SSDT 0xFFFF89FB80875700 0000F4 (v02 PmRef Cpu0Psd 00003000 INTL 20160527)
[ 0.342634] ACPI: SSDT 0xFFFF89FB80369A00 00011B (v02 PmRef Cpu0Hwp 00003000 INTL 20160527)
[ 0.344203] ACPI: SSDT 0xFFFF89FB803D3000 000724 (v02 PmRef HwpLvt 00003000 INTL 20160527)
[ 0.346032] ACPI: SSDT 0xFFFF89FB80809800 000317 (v02 PmRef ApHwp 00003000 INTL 20160527)
[ 0.347815] ACPI: SSDT 0xFFFF89FB8222C000 000AB0 (v02 PmRef ApPsd 00003000 INTL 20160527)
[ 0.350251] ACPI: SSDT 0xFFFF89FB8080BC00 00030A (v02 PmRef ApCst 00003000 INTL 20160527)
[ 1.606863] megasas: 07.734.00.00-rc1
[ 1.612883] megaraid_sas 0000:06:00.0: BAR:0x0 BAR's base_addr(phys):0x0000004000100000 mapped virt_addr:0x00000000ba245428
[ 1.613059] megaraid_sas 0000:06:00.0: FW now in Ready state
[ 1.613339] megaraid_sas 0000:06:00.0: 63 bit DMA mask and 63 bit consistent mask
[ 1.613981] megaraid_sas 0000:06:00.0: firmware supports msix : (16)
[ 1.627433] megaraid_sas 0000:06:00.0: requested/available msix 5/5 poll_queue 0
[ 1.627692] megaraid_sas 0000:06:00.0: current msix/max num queues : (5/4)
[ 1.627929] megaraid_sas 0000:06:00.0: RDPQ mode : (enabled)
[ 1.628152] megaraid_sas 0000:06:00.0: Current firmware supports maximum commands: 1517 LDIO threshold: 0
[ 1.635582] megaraid_sas 0000:06:00.0: Performance mode :Latency (latency index = 1)
[ 1.635862] megaraid_sas 0000:06:00.0: FW supports sync cache : Yes
[ 1.637033] ahci 0000:00:17.0: AHCI vers 0001.0301, 32 command slots, 6 Gbps, RAID mode
[ 1.637270] ahci 0000:00:17.0: 8/8 ports implemented (port mask 0xff)
[ 1.637490] ahci 0000:00:17.0: flags: 64bit ncq sntf pm clo only pio slum part ems deso sadm sds apst
[ 1.642227] megaraid_sas 0000:06:00.0: megasas_disable_intr_fusion is called outbound_intr_mask:0x40000009
[ 1.661726] scsi host1: ahci
[ 1.676945] scsi host2: ahci
[ 1.686072] scsi host3: ahci
[ 1.693181] scsi host4: ahci
[ 1.696364] scsi host5: ahci
[ 1.699908] scsi host6: ahci
[ 1.704331] scsi host7: ahci
[ 1.704767] scsi host8: ahci
[ 1.705116] ata1: SATA max UDMA/133 abar m2048@0x92102000 port 0x92102100 irq 136 lpm-pol 1 ext
[ 1.705391] ata2: SATA max UDMA/133 abar m2048@0x92102000 port 0x92102180 irq 136 lpm-pol 1 ext
[ 1.705647] ata3: SATA max UDMA/133 abar m2048@0x92102000 port 0x92102200 irq 136 lpm-pol 1 ext
[ 1.705892] ata4: SATA max UDMA/133 abar m2048@0x92102000 port 0x92102280 irq 136 lpm-pol 1 ext
[ 1.706195] ata5: SATA max UDMA/133 abar m2048@0x92102000 port 0x92102300 irq 136 lpm-pol 1 ext
[ 1.706429] ata6: SATA max UDMA/133 abar m2048@0x92102000 port 0x92102380 irq 136 lpm-pol 1 ext
[ 1.706661] ata7: SATA max UDMA/133 abar m2048@0x92102000 port 0x92102400 irq 136 lpm-pol 1 ext
[ 1.706914] ata8: SATA max UDMA/133 abar m2048@0x92102000 port 0x92102480 irq 136 lpm-pol 1 ext
[ 2.014731] ata3: SATA link down (SStatus 0 SControl 300)
[ 2.014981] ata8: SATA link down (SStatus 0 SControl 300)
[ 2.015653] ata6: SATA link down (SStatus 0 SControl 300)
[ 2.016431] ata4: SATA link down (SStatus 0 SControl 300)
[ 2.017166] ata7: SATA link up 1.5 Gbps (SStatus 113 SControl 300)
[ 2.017877] ata5: SATA link down (SStatus 0 SControl 300)
[ 2.018856] ata2: SATA link down (SStatus 0 SControl 300)
[ 2.019598] ata1: SATA link down (SStatus 0 SControl 300)
[ 7.337082] megaraid_sas 0000:06:00.0: Ignore DCMD timeout: megasas_get_ctrl_info 5387
[ 7.337341] megaraid_sas 0000:06:00.0: Could not get controller info. Fail from megasas_init_adapter_fusion 1905
[ 7.343278] megaraid_sas 0000:06:00.0: Failed from megasas_init_fw 6549

 

[news]

i search google for "530-8i raid controller proxmox" and found many results.
Maybe your kernel don't support this type of card.
So check this by your selve with your Proxmox VE and Debian 13 Version.