unable to resolve networking issue

[andrew_s]

I built a test environment on some old HP kit, it was flawless

Now running Promax on a Moonshot cartridge

configured networking at install, chose interface 0 - installation completes ., but no networking

run through many of the posts here to try and resolve - here is where I am now - ideally this should communicate on vlan 63

the switches are presenting all vlans to the interfaces

still no joy - I must be missing something very obvious

auto lo
iface lo inet loopback

iface eno1np0 inet manual

auto vmbro inet manual
bridge-ports eno1np0
bridge-stp off
bridge-fd 0
bridge-vlan-aware yes
bridge-vids 2-4094

auto vmbr0.63
iface vmbr0.63 inet static
address 172.16.74.102/24
gateway 172.16.74.254

 

[Dunuin]

auto lo
iface lo inet loopback

iface eno1np0 inet manual

auto vmbro inet manual
bridge-ports eno1np0
bridge-stp off
bridge-fd 0
bridge-vlan-aware yes
bridge-vids 2-4094

auto vmbr0.63
iface vmbr0.63 inet static
address 172.16.74.102/24
gateway 172.16.74.254

Except for the "auto vmbro inet manual" that should be ...

auto vmbr0
iface vmbr0 inet manual

...it looks fine.

 

[andrew_s]

thank you - that was just a typo in the post , rather then an error in the config file (I am very dyslexic so have to check very carefully) - you have confirmed my suspicions that it can't be this hard, I have been going in loops for days- I think i may just pop on a standard linux build and see if I can get the networking stood up on that - could it be networking drivers - they appear fine in the gui install phase so seems unlikely, thank you.