Hi,
I previously had PBS installed on a Dell R710 alongside PVE 7.x - This was a couple of years ago, so I can't remember which version of PBS it was. The server was damaged, and has been unused since.
I've now installed PVE 9.2.3 and PBS 4.2.1 on an R730, and moved the HP 1/8 G2 Autoloader, along with the SCSI interface card, to the new machine. I have added the autoloader to the 'Changers' section, but when I go to add the drive itself, the dropdown menu for 'Path' is blank.
Looking at a copy of tape.cfg from the old server, it was using '/dev/tape/by-id/scsi-12345678-sg' (serial redacted). On the new server, only scsi-12345678 and scsi-12345678-nst show up in /dev, but neither is available to select from the GUI.
Any advice please?
I previously had PBS installed on a Dell R710 alongside PVE 7.x - This was a couple of years ago, so I can't remember which version of PBS it was. The server was damaged, and has been unused since.
I've now installed PVE 9.2.3 and PBS 4.2.1 on an R730, and moved the HP 1/8 G2 Autoloader, along with the SCSI interface card, to the new machine. I have added the autoloader to the 'Changers' section, but when I go to add the drive itself, the dropdown menu for 'Path' is blank.
Looking at a copy of tape.cfg from the old server, it was using '/dev/tape/by-id/scsi-12345678-sg' (serial redacted). On the new server, only scsi-12345678 and scsi-12345678-nst show up in /dev, but neither is available to select from the GUI.
Any advice please?