SMART error (Health) detected on host: proxmox

[MarcinTD]

Is there any way to fix it or just replace the disk?

This message was generated by the smartd daemon running on:
host name: proxmox
DNS domain: xyz.xyz
The following warning/error was logged by the smartd daemon:
Device: /dev/bus/0 [megaraid_disk_09], SMART Failure: HARDWARE IMPENDING FAILURE DATA ERROR RATE TOO HIGH
Device info:
[TOSHIBA AL14SEB090N 0103], lu id: 0x50000399681ae7d9, S/N: AAABBBCCCDDD, 900 GB
For details see host's SYSLOG.
You can also use the smartctl utility for further investigation.
The original message about this issue was sent at Wed Aug 14 21:14:53 2024 CEST Another message will be sent in 24 hours if the problem persists.

 

[waltar]

The disk should be replaced but take a look into the ctrl. with storcli/megacli/perccli (depending on hw model) for defect disk and serial while "[megaraid_disk_09]" maybe mostly isn't the disk nr. 9 (because of address mapping) !