I just tried to get a new cluster to work. To my surprise I got this:
Gathering 1024 bits for key from /dev/urandom.
Writing corosync key to /etc/corosync/authkey.
Job for corosync.service failed. See 'systemctl status corosync.service' and 'journalctl -xn' for details.
command 'systemctl restart corosync' failed: exit code 1
..and this:
root@pve01:~# systemctl status corosync.service -l
...
Mar 14 13:33:27 pve01 corosync[1875]: [QUORUM] Quorum provider: corosync_votequorum failed to initialize.
Mar 14 13:33:27 pve01 corosync[1875]: [SERV ] Service engine 'corosync_quorum' failed to load for reason 'configuration error: nodelist or quorum.expected_votes must be configured!'
...
root@pve01:~#
...and this:
root@pve01:~# pvecm status
Cannot initialize CMAP service
I am just posting it for others to spare them some time. I had a clean installation of the Proxmox 4.1 (or so I thought) but the ip address of the node was changed right after the installation before joining a cluster. If you decide to change your ip (again before joining a cluster) you need to change it also in the host file as it is being used by the corosync.conf file and the ips don't mach.
Thank you
Gathering 1024 bits for key from /dev/urandom.
Writing corosync key to /etc/corosync/authkey.
Job for corosync.service failed. See 'systemctl status corosync.service' and 'journalctl -xn' for details.
command 'systemctl restart corosync' failed: exit code 1
..and this:
root@pve01:~# systemctl status corosync.service -l
...
Mar 14 13:33:27 pve01 corosync[1875]: [QUORUM] Quorum provider: corosync_votequorum failed to initialize.
Mar 14 13:33:27 pve01 corosync[1875]: [SERV ] Service engine 'corosync_quorum' failed to load for reason 'configuration error: nodelist or quorum.expected_votes must be configured!'
...
root@pve01:~#
...and this:
root@pve01:~# pvecm status
Cannot initialize CMAP service
I am just posting it for others to spare them some time. I had a clean installation of the Proxmox 4.1 (or so I thought) but the ip address of the node was changed right after the installation before joining a cluster. If you decide to change your ip (again before joining a cluster) you need to change it also in the host file as it is being used by the corosync.conf file and the ips don't mach.
Thank you
