Busy getting to understand some stuff with the SDN EVPN zone, and I notice it generates 2x sets of VxLAN-bridge pairs.
What is the motivation and reason/use for that extra pair named vrf_.....?
If it is not used in my case, is there perhaps a switch to turn it off/disable it?
Reason I'm asking is that you can't create VLAN tags on the VNETs in the EPVN and well.. *my* setup I don't use the PVE nodes as "Exit-nodes" but I have another layer (that has the outside routing) where the internal firewalls (again, not using in my case the PVE firewall as I'm using another OEN firewall VM)
What is the motivation and reason/use for that extra pair named vrf_.....?
If it is not used in my case, is there perhaps a switch to turn it off/disable it?
Reason I'm asking is that you can't create VLAN tags on the VNETs in the EPVN and well.. *my* setup I don't use the PVE nodes as "Exit-nodes" but I have another layer (that has the outside routing) where the internal firewalls (again, not using in my case the PVE firewall as I'm using another OEN firewall VM)