Hi
I was wondering if someone could shed some light,
Currently normally i would configure VirtIO SCSI but i have read that using VirtIO SCSI single is better?
as for the bus device i normally use SCSI but should i change to VirtIO? while running ZFS on proxmox?
Normally i would run something like this attaching photo, I was reading also on IO thread sometimes the VM gets locked up not sure if its recommended to use at the moment?
as for the SSD emulation i assume only checkmark if running SSD on proxmox?
Thank you
I was wondering if someone could shed some light,
Currently normally i would configure VirtIO SCSI but i have read that using VirtIO SCSI single is better?
as for the bus device i normally use SCSI but should i change to VirtIO? while running ZFS on proxmox?
Normally i would run something like this attaching photo, I was reading also on IO thread sometimes the VM gets locked up not sure if its recommended to use at the moment?
as for the SSD emulation i assume only checkmark if running SSD on proxmox?
Thank you