QEMU Exited With Code 1 When Adding 10G Network

M

Misinthe

Member
Feb 2, 2022
5
1
8
37
Good evening everyone, I'm relatively new to Proxmox, one of my Nodes has a 4 x 10GB Network Card, so I figured I would make use of it, so I added the connection and created the Linux Bridge with it, I then added the bridge to my Windows Server 2022 VM and when I try to start the Server again it gives me a QEMU Exited with Code 1 error, if I take the bridge off it starts up with no problems, I'm not sure what the problem is here, any suggestions would be greatly appreciated.
 
Please post /etc/network/interfaces (redact any sensitive ip information) and /etc/qemu-server/<vm-id>.conf
 
bobmc said:
Please post /etc/network/interfaces (redact any sensitive ip information) and /etc/qemu-server/<vm-id>.conf
Click to expand...
Seems all I needed to do was restart the Node after creating the bridge, it's working now. Thank you though!
 
You must log in or register to reply here.
Top Bottom