QEMU Exited With Code 1 When Adding 10G Network

[Misinthe]

Good evening everyone, I'm relatively new to Proxmox, one of my Nodes has a 4 x 10GB Network Card, so I figured I would make use of it, so I added the connection and created the Linux Bridge with it, I then added the bridge to my Windows Server 2022 VM and when I try to start the Server again it gives me a QEMU Exited with Code 1 error, if I take the bridge off it starts up with no problems, I'm not sure what the problem is here, any suggestions would be greatly appreciated.

 

[bobmc]

Please post /etc/network/interfaces (redact any sensitive ip information) and /etc/qemu-server/<vm-id>.conf

 

[Misinthe]

Please post /etc/network/interfaces (redact any sensitive ip information) and /etc/qemu-server/<vm-id>.conf

Seems all I needed to do was restart the Node after creating the bridge, it's working now. Thank you though!