Hello,
Trying to install on PVE 5.0 on a DELL Poweredge C1100, and it does not appear to be detecting the hardware raid array correctly. While it does see that 4 disks, they are detected individually - even though a valid RAID10 array is defined and operational.
Base on the RAID BIOS config, it shows Intel Matrix Storage Mgr 8.9.1. See screenshot below:
During installation, the available targets list all 4 disks (not a single volume):
After setup, the software is loaded on the first disk:
Then the array is in a degraded state with that disk excluded.
Is there any way to get PVE 5.x to see the full RAID array and not break it? I suppose I could use the ZFS RAID 10 option of PVE, but I am thinking the hardware RAID would be much faster.
Any advice or guidance would be greatly appreciated.
Stefan
Trying to install on PVE 5.0 on a DELL Poweredge C1100, and it does not appear to be detecting the hardware raid array correctly. While it does see that 4 disks, they are detected individually - even though a valid RAID10 array is defined and operational.
Base on the RAID BIOS config, it shows Intel Matrix Storage Mgr 8.9.1. See screenshot below:
During installation, the available targets list all 4 disks (not a single volume):
After setup, the software is loaded on the first disk:
Then the array is in a degraded state with that disk excluded.
Is there any way to get PVE 5.x to see the full RAID array and not break it? I suppose I could use the ZFS RAID 10 option of PVE, but I am thinking the hardware RAID would be much faster.
Any advice or guidance would be greatly appreciated.
Stefan
Last edited: