Proxmox installation with Intel I5 13400 fails.

[Andre Reis]

Hello,

This is my first time on this forum and I am very new to Proxmox. I am trying to install the Proxmox 7.4 but I am getting this error: “Cannot run in frame buffer mode. Please specify BusID”. I have tried several times to edit the configuration file (recommended here on this forum), but the installation always fails.

When I try the run the command lspci I can’t identify any graphic card from the list (attached image):


Section "Device"
Identifier "Card0"
Driver "fbdev"
BusID "pci0:01:0:0:" <—— (I have tried dozens of combinations of BusIDs here)
EndSection

Computer specs:
Motherboard: MSI MAG B760M MORTAR LGA 1700
CPU: Intel I5 13400

Additional information:
I have secure boot disable and virtualisation enable on motherboard BIOS, boot mode = UEFI and Initiate Graphic Card = IGD.
This same USB with Proxmox ISO was used to install Proxmox in another PC without any issues.
I have tried this installation using two different SSDs: Sata SSD and M.2 SSD.
If I bring back this SSD with Proxmox that was working in another computer, Proxmox doesn’t start and I get the error image attached.

I would appreciate any help to fix this issue.

 

[noel.]

I think our default 5.15 kernel doesn't support the 13400 because it is too new. Try installing Debian and then installing Proxmox on top [1] but instead of installing the pve-kernel-5.15 install pve-kernel-6.2.

Hope this helps

---

[1]: https://pve.proxmox.com/wiki/Install_Proxmox_VE_on_Debian_11_Bullseye