Proxmox HCI Hardware Maintenance

[luigi]

Hello everybody,
I have a HCI with three nodes that function as storage and HA clusters.

The proxmox version is 6.2 and everything has been working fine for two years.

Now I have a fault on a Quadport Eth10G and I have to replace it.

Is there a proxmox procedure that I have to follow for this case?
Or I just poweroff the node and change the fault hardware component?


The three nodes will have the following characteristics:
2x CPU 8Cores
128 GB of DDr4 RAM
2x 240GB HD SSD mirrored for proxmox
4x HD SSD 1TB for OSD
6x HD 8TB 7.2Krpm for backup
1x QuadPort Eth1G --> traffic VM
1x QuadPort Eth10G --> traffic ceph storage


Best regards
Luigi

 

[LnxBil]

Or I just poweroff the node and change the fault hardware component?

If you plug in the same card (vendor, product) in the same slot, there should not be any problem unless you configured mac addresses yourself.