promox installer does not boot

[etresein]

Hello everyone,

I have replaced my CPU, mainboard and ram because I finally wanted to switch to ECC ram. However, I can't get the system to run. I do everything as usual and the installation of Promox is not even possible. I suspect that some BIOS setting is not correct or I have overlooked something else. Perhaps a driver is also missing. I can boot the USB stick with the Promoxinstaller. I select the graphical menu and then it always hangs at the beginning. See picture. Does anyone have a tip?

I tried install promox 8.2

Hardware:
Supermicro X10RSA
2x 3ware 9650se-4lpmml
xeon e5-1650 v3
png quaddro graphics card

As I have already said, the system ran without any problems before with the two Sata cards and the graphics card

 

[etresein]

I have solved the problem. I had to move all the cards to the picke spots, which were located directly on the cup. I then loaded promox version 7.4 and it worked. what a struggle...