Problem with new KVM in a Clusternode

[pingux]

Hi,

I have a Problem when i create a new KVM like Ubuntu or another System on a node. I can start the VM, but i see only the virtuel biosscreen. The CPU is on 98%. This is always the same on each node. But when i migrate or create a KVM on the Master or single Proxmox, KVM starts normaly. Has any one an idea whats the problem? This Problem is only on 1.4. On 1.2 kvm runs normaly.

Biosscreen: klick

greetings
pingux

 

[tom]

Hi,

I have a Problem when i create a new KVM like Ubuntu or another System on a node. I can start the VM, but i see only the virtuel biosscreen. The CPU is on 98%. This is always the same on each node. But when i migrate or create a KVM on the Master or single Proxmox, KVM starts normaly. Has any one an idea whats the problem? This Problem is only on 1.4. On 1.2 kvm runs normaly.

Biosscreen: klick

greetings
pingux

do you use the same version on all nodes?

check output of 'pveversion -v'

 

[pingux]

Thank you for your answer

Yes all Systems are the same version.

pve-manager: 1.4-9 (pve-manager/1.4/4390)
qemu-server: 1.1-8
pve-kernel: 2.6.24-16
pve-qemu-kvm: 0.11.0-2
pve-firmware: 1
vncterm: 0.9-2
vzctl: 3.0.23-1pve3
vzdump: 1.2-5
vzprocps: 2.0.11-1dso2
vzquota: 3.0.11-1

Greetings
pingux
_________________-
Ok i have found another problem. I think the Hardware is not compatible with proxmox. (VIA NANO) i belief i had only openvz on this two machines, not kvm. In installed Version 1.2; the same Problem. But with Ubuntu on this this Harware KVM works. Why? ....

Greetings
Pingux