Passthrough Raspberry 5 Bluetooth

[marcor2196]

Hi all,
I have installed pimox on Raspberry 5 where I have a VM with Home Assistant.

I would like to use the Raspberry's built-in Bluetooth, but I can't figure out how to do it because I don't see it in the output of lsusb or even in lspci:

# lspci
0000:00:00.0 PCI bridge: Broadcom Inc. and subsidiaries BCM2712 PCIe Bridge (rev 21)
0000:01:00.0 Non-Volatile memory controller: Sandisk Corp WD Green SN350 240GB (DRAM-less) / SN560E NVMe SSD
0001:00:00.0 PCI bridge: Broadcom Inc. and subsidiaries BCM2712 PCIe Bridge (rev 21)
0001:01:00.0 Ethernet controller: Raspberry Pi Ltd RP1 PCIe 2.0 South Bridge

# lsusb
Bus 004 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 003 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 001 Device 002: ID 10c4:ea60 Silicon Labs CP210x UART Bridge
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub

With rfkill and hciconfig I can see it:

# rfkill
ID TYPE      DEVICE      SOFT      HARD
 0 bluetooth hci0   unblocked unblocked
 1 wlan      phy0   unblocked unblocked
 
# hciconfig
hci0:   Type: Primary  Bus: UART
        BD Address: 2C:CF:67:19:7B:71  ACL MTU: 1021:8  SCO MTU: 64:1
        UP RUNNING
        RX bytes:4051 acl:0 sco:0 events:401 errors:0
        TX bytes:67983 acl:0 sco:0 commands:401 errors:0

In the dashboard of Proxmox, I see that in PCI mapping window:



Thank you for the help!!

 

[UdoB]

Unfortunately there is no Raspberry support from Proxmox, the company. PVE requires "CPU: 64bit (Intel 64 or AMD64)" - https://pve.proxmox.com/pve-docs/pve-admin-guide.html#install_minimal_requirements

Probably you've got that software from somewhere else. Look for a "Readme" or other documentation to find hints regarding support.

Best regards!