Confirmed that the r8159u works with in-tree driver on my N100 minipc but lack of firmware causes failure to up nic at 10gbe. It will negotiate 5gbe when asked.
Worked at 10gbe achieved ~8.3gbe on usb3 Gen 2x1 which is better than the 7.5gbe I got with v2.22.1 dkms on the warm boot from 7.0 w/ dkms but failed after cold boot.
Worked at 10gbe achieved ~8.3gbe on usb3 Gen 2x1 which is better than the 7.5gbe I got with v2.22.1 dkms on the warm boot from 7.0 w/ dkms but failed after cold boot.
[ 1.548550] usb 2-4: New USB device strings: Mfr=1, Product=2, SerialNumber=7[ 1.548552] usb 2-4: Product: USB 10/100/1G/2.5G/5G/10G LAN[ 1.548553] usb 2-4: Manufacturer: CMI[ 1.548554] usb 2-4: SerialNumber: xxxx[ 1.559689] r8152: unknown parameter 'rss' ignored[ 1.559745] usbcore: registered new device driver r8152-cfgselector[ 1.675173] r8152-cfgselector 2-4: reset SuperSpeed Plus Gen 2x1 USB device number 2 using xhci_hcd[ 1.692641] r8152 2-4:1.0: Direct firmware load for rtl_nic/rtl8159-1.fw failed with error -2[ 1.692645] r8152 2-4:1.0: unable to load firmware patch rtl_nic/rtl8159-1.fw (-2)[ 1.739890] usbcore: registered new interface driver r8152[ 1.746372] r8152 2-4:1.0 usbnet0: renamed from eth0[ 3.722338] r8152-cfgselector 2-4: reset SuperSpeed Plus Gen 2x1 USB device number 2 using xhci_hcd[ 3.755894] r8152 2-4:1.0: Direct firmware load for rtl_nic/rtl8159-1.fw failed with error -2[ 3.755901] r8152 2-4:1.0: unable to load firmware patch rtl_nic/rtl8159-1.fw (-2)[ 3.929203] r8152 2-4:1.0 usbnet0: renamed from eth0[ 5.845390] r8152 2-4:1.0 usbnet0: entered allmulticast mode[ 5.845441] r8152 2-4:1.0 usbnet0: entered promiscuous mode...root@pve06:~# ip -br addrusbnet0 DOWNroot@pve06:~# ethtool -s usbnet0 speed 5000 duplex full autoneg onsleep 10; ethtool usbnet0 | grep -E 'Speed|Link detected' Speed: 5000Mb/s Link detected: yesroot@pve06:~# ip -br addrusbnet0 UProot@pve06:~# ethtool -i usbnet0driver: r8152version: 7.3.5-1-pvefirmware-version:expansion-rom-version:bus-info: usb-0000:00:14.0-4supports-statistics: yessupports-test: nosupports-eeprom-access: nosupports-register-dump: nosupports-priv-flags: no