OpenVZ --> LXC - Process stop running

[3dhomejoe]

Hello All,

I am in the process of migrating from Proxmox 3.4 to 4.1 and I've ran into a slight roadblock.
My email server is running Ubuntu 14.04.2 LTS and uses Zimbra 8.6 (Open Source Edition), the system is fully functional in the OpenVZ environment; however, after running a backup, migrating the server over to the new LXC system, and assigning IP addresses, the processes for Zimbra get "terminated" when the system gets to the login prompt on the terminal.
When the LXC container is booting, I am able to ssh into the server and I can see the normal process starting for Zimbra before the login prompt is shown in the terminal; however, once the login prompt is shown, the process disappear.

I've included a few screenshots of the units. Any advice would be very helpful.

Thank You,
Joseph.

- LXC displayed on top, OpenVZ on the bottom.
- Run levels for both VM's.
- LXC booting with Zimbra Process starting/running.

 

[ned]

would love to know if you get zimbra running in lxc and the performance in lxc.

 

[amelchor]

I have the same problem, I just /etc/init.d/zimbra start and it work, you habe to make the same each time you reboot your server.

 

[3dhomejoe]

I have the same problem, I just /etc/init.d/zimbra start and it work, you habe to make the same each time you reboot your server.

I'll give that a try and see if Zimbra will start. It is a work around but it is not the best solution to the issue.

 

[Carlos Estrada]

Hi.

I think I have the same problem. I already posted it on zimbra forum:

https://community.zimbra.com/collaboration/f/1928/t/1140938

No answer yet.

Does someone know what is the problem?

 

[3dhomejoe]

I have not been able to solve the issue yet.