OpenSUSE 15.6 LXC appears broken

[70tas]

Tried to repeatedly install, and downloaded three times after deleting. However, the LXC CT shows started, but the console has a blinking cursor and just stays there.
Has any one else had this issue, and has there been a fix?

 

[Kingneutron]

Go to LXC Options / Console mode and set it to Shell, then cold shutdown/restart it

 

[70tas]

I forced sropped from GUI, then restarted. Same results. Is that what you meant?

 

[Kingneutron]

https://github.com/kneutron/ansitest/blob/master/proxmox/proxmox-enter-container.sh

Try this, if it doesn't work then you have a bad image

 

[70tas]

https://github.com/kneutron/ansitest/blob/master/proxmox/proxmox-enter-container.sh

Try this, if it doesn't work then you have a bad image

That worked. But I should still be able to open it through the console, shouldn't I?
Cheers

 

[70tas]

@Kingneutron I'm trying to setup a container with a light gui for Handbrake. In the end I used OpenSUSE Leap 15.6 with flatpak on a host specifically for using the i630 drivers. I tested it against a Windows VM with full GPU split and H.26t4 2160p 4K.
I am getting 60 frames per second average on Win, versus 250 frames per second on Leap via flatpak.

I did try flatpak on OpenSUSE Tumbleweed, but it keeps crashing the Proxmox host.
I will try again, but thank you for your help.