Onbord RAID controller on Intel SR2600URLX

[nick]

Regarding to this post:

http://www.proxmox.com/forum/showthread.php?p=16796#poststop

I make some tests to see if I can measure the PVE performance on RAID 0 and RAID 10 using onbord RAID controllers.
To be onest, I'm not familiar (too much) with this controllers; but, I have this platform (Intel SR2600URLX) for testing in this moment.

Also I have available 2 x SAS Seagate 15k rpm. Now, I make the test for a single disk install and everything it's OK.

I activate RAID 0 on LSI onboard controller, the PVE 1.4 see the RAID 0 disk, make the install, but the system don't boot.

Can anyone tell me what I do wrong? I need to do something special?

Thank you!

 

[udo]

Hi,
perhaps you must set the boot-order in the bios new, due to deleting of the raid-1 and building the raid-0?

Udo

 

[nick]

I never configure RAID 1...I use on fisrt test a single disk - no raid.

I check again the BIOS settings...