Hi I have a fully running and relatively new Gen8 NUC all is going well BUT I have realised that after a power outage it is not set up to auto restart. I read this can be done through the bios. For whatever reason I cannot seem to get to the bios, I hit F2 go down to the system setup option hit enter and the screen goes blank.
Therefore I wondered if there was perhaps a command I could input through the console, or anything else through Proxmox to achieve this.
Thanks for help.
Therefore I wondered if there was perhaps a command I could input through the console, or anything else through Proxmox to achieve this.
Thanks for help.
