New SSID not showing up during installation

Maikel0606

New Member
May 16, 2023
3
1
3
Hi,

I just installed a new Samsung NVMe M.2 SSD in my system, but the hard drive is now showing up during installation.
When i run a Windows installation the drive is showing.

What to do?
 
Maybe the drive is not empty? Try issuing:

fdisk /dev/sdX
d (for delete the partition, even if none exists)
w (to write back to the disk)

Then you should see the disk in your Proxmox gui. I had to do something similar to used disks that I got out of ebay that had some data on them.
 
Maybe the drive is not empty? Try issuing:

fdisk /dev/sdX
d (for delete the partition, even if none exists)
w (to write back to the disk)

Then you should see the disk in your Proxmox gui. I had to do something similar to used disks that I got out of ebay that had some data on them.
Hi ibravo,
The drive is new, i formatted it but it is not showing in the GUI and during installation..
 
Issue resolved

I needed to install a bios update, next i was able to disable the "Configure Storage Controller for Intel Optane" in the bios.

Thanks!
 
  • Like
Reactions: leesteken