Hello Proxmox community,
I recently built a NAS workstation using an AMD Ryzen 5 5000 series processor, GIGABYTE B550 AORUS ELITE AX V3 (rev.1.5), 4x 4TB HDDs connected via an LSI Broadcom SAS 9300-8i controller, and 2x 512MB SSDs connected to SATA ports 1 and 2 and formatted into a ZFS RAID1 configuration. When I enable virtualization on the motherboard, the workstation's keyboard freezes, and I'm unable to ping the system due to network failure. However, when I disable virtualization, the system works fine, but I cannot utilize the workstation's capabilities without it enabled.
Do you have any suggestions for resolving this issue? Is my motherboard compatible with Proxmox, or is there a compatibility issue between AMD and Proxmox?
I recently built a NAS workstation using an AMD Ryzen 5 5000 series processor, GIGABYTE B550 AORUS ELITE AX V3 (rev.1.5), 4x 4TB HDDs connected via an LSI Broadcom SAS 9300-8i controller, and 2x 512MB SSDs connected to SATA ports 1 and 2 and formatted into a ZFS RAID1 configuration. When I enable virtualization on the motherboard, the workstation's keyboard freezes, and I'm unable to ping the system due to network failure. However, when I disable virtualization, the system works fine, but I cannot utilize the workstation's capabilities without it enabled.
Do you have any suggestions for resolving this issue? Is my motherboard compatible with Proxmox, or is there a compatibility issue between AMD and Proxmox?