I have done a search and this has been asked a few times before but I haven't been able to find the answer. I have a NAT setup following this guide:
https://pve.proxmox.com/pve-docs/chapter-sysadmin.html#_choosing_a_network_configuration
The server has 10gbit public interface and I just can't get the throughput with pfSense virtualised so have opted to go for a PVE NAT config which so far works perfectly and gives the full throughput. I have been assigned a public /29 range and wish to add those to the eno2 adapter so I can use some port fowarding rules. My network config looks like this (public IP redacted):
Would something like this be correct?
https://pve.proxmox.com/pve-docs/chapter-sysadmin.html#_choosing_a_network_configuration
The server has 10gbit public interface and I just can't get the throughput with pfSense virtualised so have opted to go for a PVE NAT config which so far works perfectly and gives the full throughput. I have been assigned a public /29 range and wish to add those to the eno2 adapter so I can use some port fowarding rules. My network config looks like this (public IP redacted):
Code:
auto lo
iface lo inet loopback
auto eno2
iface eno2 inet static
address X.X.X.X/29
gateway X.X.X.X
iface eno1 inet manual
auto vmbr0
iface vmbr0 inet static
address 172.16.10.1/24
bridge-ports none
bridge-stp off
bridge-fd 0
post-up echo 1 > /proc/sys/net/ipv4/ip_forward
post-up iptables -t nat -A POSTROUTING -s '172.16.10.0/24' -o eno2 -j MASQUERADE
post-down iptables -t nat -D POSTROUTING -s '172.16.10.0/24' -o eno2 -j MASQUERADE
Would something like this be correct?
Code:
auto eno2
iface eno2 inet static
address X.X.X.X/29
gateway X.X.X.X
iface eno2:0 inet static
address X.X.X.X/29
Last edited: