Migrating between nodes with different network configurations

[bqq100]

I have 4 nodes that are all currently setup with vmbr0 and all VMs/Containers are connected to vmbr0. Migration works well between all of the nodes.

One of the nodes I am planning on converting to a bonded network so VMs/containers will be connected to bond0 for this node. How will migration work with the differing network names? qm migrate seems to have a targetstorage option, but no such option for networking.

Will I have to setup 1 NIC Bonded networks for my other nodes so they are all bond0? One of the nodes is hooked up to a pretty basic switch which doesn't support LAG at all, will that be an issue?

Thanks!

 

[spirit]

if you have vmbr0 on both nodes, it should work without any problem.

you can have vmbr0+bond on 1 node, and vmbr0+eth0 on another node, no problem.

 

[bqq100]

if you have vmbr0 on both nodes, it should work without any problem.

you can have vmbr0+bond on 1 node, and vmbr0+eth0 on another node, no problem.

Ah so I can set bond0 as a Bridge Port for vmbr0? I thought I would have to remove vmbr0 and replace it with bond0.

 

[spirit]

Ah so I can set bond0 as a Bridge Port for vmbr0? I thought I would have to remove vmbr0 and replace it with bond0.

no, you always plug a vm in a bridge "vmbrX", then in vmbrX you plug your physical interface (eth or bond).