Hello,
I get this error message after a reboot :
There are 2 network card (eth2 and eth3) only eth2 up but no traffic forward.
Some idea to resolve this or it is an hardware problem ?
Thanks
I get this error message after a reboot :
Code:
3.811742] ixgbe: Intel(R) 10 Gigabit PCI Express Network Driver - version 5.1.0-k
[ 3.811743] ixgbe: Copyright (c) 1999-2016 Intel Corporation.
[ 5.168652] ixgbe 0000:03:00.0: Multiqueue Enabled: Rx Queue count = 16, Tx Queue count = 16 XDP Queue count = 0
[ 5.239579] ixgbe 0000:03:00.0: MAC: 5, PHY: 7, PBA No: 020000-000
[ 5.239581] ixgbe 0000:03:00.0: 0c:c4:7a:77:f9:fe
[ 5.293853] ixgbe 0000:03:00.0: Intel(R) 10 Gigabit Network Connection
[ 5.369386] ixgbe 0000:03:00.1: HW Init failed: -17
[ 5.369747] ixgbe: probe of 0000:03:00.1 failed with error -17
[ 7.825112] ixgbe 0000:03:00.0: registered PHC device on eth2
[ 12.429523] ixgbe 0000:03:00.0: removed PHC on eth2
[ 12.738755] ixgbe 0000:03:00.0: registered PHC device on eth2
[ 13.014032] ixgbe 0000:03:00.0 eth2: changing MTU from 1500 to 9000
There are 2 network card (eth2 and eth3) only eth2 up but no traffic forward.
Some idea to resolve this or it is an hardware problem ?
Thanks