iSCSI target problem

[johnjdoe]

Hi,

I have a NAS QNAP TS-219P configured as SAN with iSCSI and attached to the same network as my Proxmox 1.5.

I followed http://pve.proxmox.com/wiki/Storage_Model to configure the iSCSI target. This worked fine and I can see it in the storage list. It's enabled, active and shared. However the capacity of it is n/a. When I click on it, I can see a LUN 0 with a capacity of 500GB (as configured)

Then I tried to add the LVM group as explained in the wiki. I receive the following message:

"Error: command '/sbin/vgcreate pve /dev/disk/by-id/scsi-xxxxxxxxxxxxxxxxx' failed with exit code 3"

Thanks in advance for each help!

 

[whinpo]

it seems you're trying to create a VG called pve...

there is already one VG called pve for the local disks...

try with another name?

 

[johnjdoe]

Ha, this worked! Thanks!