iscsi (multipath) configuration without using GUI

L

LuisManson

Member
Nov 29, 2013
9
0
21
Argentina
Hello, I've setup my iSCSI with authentication and done the Proxmox configuration using the shell with the "iscsiadm", also setup an lvm-thin on it. Since using the GUI did not allow for password and also added a dummy storage entry in the datacenter too. Is this ok?

Now I want to enable multipath too but the guide suggests to use the GUI to add the iscsi storage and some forum results start with this same step too.
Is this really needed?
 
No, you can configure your iSCSI/multipath completely via native Linux tools and then point your PVE to the resulting mpath device for LVM.
As long as you properly set everything up, you will be fine. Make sure you reboot your host to test the configuration is properly entered and you still have your storage after reboot.

Blockbridge: Ultra low latency all-NVME shared storage for Proxmox - https://www.blockbridge.com/proxmox
 
  • Like
Reactions: LuisManson
You must log in or register to reply here.

About

The Proxmox community has been around for many years and offers help and support for Proxmox VE, Proxmox Backup Server, and Proxmox Mail Gateway.
We think our community is one of the best thanks to people like you!

Quick Navigation

Home Get Subscription Wiki Downloads Proxmox Customer Portal About

Get your subscription!

The Proxmox team works very hard to make sure you are running the best software and getting stable updates and security enhancements, as well as quick enterprise support. Tens of thousands of happy customers have a Proxmox subscription. Get yours easily in our online shop.

Buy now!
Community platform by XenForo® © 2010-2024 XenForo Ltd.
Top Bottom
Back