ProxMox installation was successful on NMVe 1TB - PCIe adapter installed. However couldn't boot from there so I installed ProxMox VE on two SATA SSDs in RAID 1 mode. When booted I can see all storage capacity.
Then my 4 SAS 1.8 TB disks arrived and I installed them in the box and I can see them in iDRAC. But 'lshw' on ProxMox is not showing them at all. What can I do to configure passthrough for my NAS VM that I am going to create? I have another 1TB SATA drive which I am planning to use as single disk for another VM. Any advise, suggestion? Thanks.
Then my 4 SAS 1.8 TB disks arrived and I installed them in the box and I can see them in iDRAC. But 'lshw' on ProxMox is not showing them at all. What can I do to configure passthrough for my NAS VM that I am going to create? I have another 1TB SATA drive which I am planning to use as single disk for another VM. Any advise, suggestion? Thanks.
