Installation with the ISO 7.3-1 fails

R

rodo2023

Member
Dec 14, 2022
6
0
6
Hi,
I have an ASRock Industrial NUC BOX-1240P and the installation with the ISO 7.3-1 fails.
I suspect a problem with driver.
It is possible to use pve-kernel-6.1 or 5.19 during the installation?
 
There is no error message.
The last message is: waiting for /dev to be fully populated... than black.
 

Attachments

  • Last screen.png
    Last screen.png
    477.6 KB · Views: 36
Hi,
I also switched to the Asrock NUC Box-1240p and had the same issue: with ISO 7.3.1 or 7.2. I run into a black screen.
My solution: Install Proxmox over Debian 11 Bullseye as described here
Btw: performance of the NUC-Box ist outstanding, even with CPU governor on powersafe
 
oek said:
Hi,
I also switched to the Asrock NUC Box-1240p and had the same issue: with ISO 7.3.1 or 7.2. I run into a black screen.
My solution: Install Proxmox over Debian 11 Bullseye as described here
Btw: performance of the NUC-Box ist outstanding, even with CPU governor on powersafe
Click to expand...
Thanks for sharing this information. I am also thinking of getting the Asrock NUC Box-1240p as a proxmox machine. Have you measured the idle power consumption?
 
JOSH7 said:
Thanks for sharing this information. I am also thinking of getting the Asrock NUC Box-1240p as a proxmox machine. Have you measured the idle power consumption?
Click to expand...
Not in detail.
But if I can trust on the analysis of my Cyberpower USV, it seems on 10-15% load (idle :)) equal to the N6000 before which is impressive.
My USV shows 37W load with the Asrock + active UBS-Hub (Homematic, Conbee II, large USB-Drive für Backup, BT-Dongle), Fritz!Box 7590 (only telephone, WLAN off), Zyxel GS1210-12, POE 4xPassive Switch powering a sip phone and a Unifi UDM 6 Pro. That's pretty fine for me.
 
You must log in or register to reply here.
Top Bottom