installation proxmox on HP PROLIANT dl 380 g10

R

rmazouzi

New Member
Jul 29, 2023
19
1
3
hello we would like to perform an installation of proxmox last release on HP PROLIANT DL 380 G10 ,

we want to install Proxmox OS on Raid 1 "miroring of 2 disques" what it is the best option is it set up hardwaire Raid of HP or setup up raidz1 (ZFS) during the installation
 
Last edited:
I would do hw-raid1 using the installed P4<xy> ctrl to choose for pve inst., and after install ssacli into pve for ctrl. access without using iLo.
 
  • Like
Reactions: carles89
i think using ZFS raidz1 is better this solution is already known by proxmox and we can monitor through pool
 
Why ask if you think go with zfs ? Do you know the nessecery steps in sequence to change an os disk and are still be able to boot from both after ?
 
waltar said:
Why ask if you think go with zfs ? Do you know the nessecery steps in sequence to change an os disk and are still be able to boot from both after ?
Click to expand...
yeah this is a important matter reallyi don't know the steps the change an impacted disk which is belong to pool zfs raidz1
 
because i already tried set up raid 1 using hardware bios but during installation of proxmox it recognize the 2 disques not just a one disque "vlm"
 
First I strongly think you are meaning zfs mirror instead off raidz1 and second test that with a new pve installation before going into production.
 
rmazouzi said:
because i already tried set up raid 1 using hardware bios but during installation of proxmox it recognize the 2 disques not just a one disque "vlm"
Click to expand...
The MR416i-a is a quiet good controller and should show just 1 virtual disk to pve. I think you did a mistake by creating the raid1 setup as the ctrl. send as empty disks out also. It's impossible to see configured disks outside the ctrl.
 
You must log in or register to reply here.
Top Bottom