Installation problem with new UCS C220 M5

[pakpoom]

We just buy new hardware for setting up proxmox to replace the old one. After setting up with bootable media and with default configuration, we ran into the problem after hit reboot. The server is not boot to promox. I have already set boot option to boot with the disk that OS installed. Do I missed some configuration or driver?

I've search through the forum but no luck to find answer

 

[Stoiko Ivanov]

Please provide some information at where the boot fails - is it a firmware/bios issue, does the proxmox-bootloader (grub or systemd-boot) hang at some point?

a screenshot would help

 

[pakpoom]

Sorry late reply
Below is detail of what I have done

Install proxmox over the first disk of the system
My system is Cisco C220 M5sx
CPU 24 core 2x12
Ram 512GB
Disk SAS 2.4 TB x9
Controller SAS HBA 12G

and deploy with default configuration


After installation finish and reboot
No grub screen or anything it boot to shell
I've already check with bios setting it select to boot with UEFI harddisk, also check to legacy boot but not boot in to proxmox. Some technical said it should be driver issue

Thanks

 

[Stoiko Ivanov]

If the install went through without error the system should have a boot-loader installed.

May try switching from UEFI boot to legacy boot (or the other way around)
And explicitly selecting the disk from which the system should boot inside the BIOS

I hope this helps!