Installation not work in local

banco29510

New Member
Nov 14, 2026
1
0
1
Hello,

I try to install Proxmox in my old computer. Before I test with virtualbox and they work.

I read this website (https://www.stephane-robert.info/docs/virtualiser/type1/proxmox/fondamentaux/installation/) in French and i don't have any problem.

I'm in local network without DHCP.

My network are : PC => switch => Proxmox server

I don't have problem during installation but when i go in admin interface don't work.

I have 2 choice for management interface NIC0 et NIC1.

I don't understand why they don't work.

Can you have idea ?

Thank you.
 
I'd check which socket the installer put on the bridge. At the Proxmox console, run ip -br link and ip -br addr, then look at the bridge-ports line under vmbr0 in /etc/network/interfaces. On a default install, the cable to the switch should go into the physical NIC named on that line. ip link show dev <NIC> should show LOWER_UP on the cabled port when it has link. You can move the cable to the configured port and test again without reinstalling. Proxmox network configuration

With no DHCP, the PC also needs a static address for this test. If vmbr0 shows 192.168.50.10/24, for example, give the PC an unused address such as 192.168.50.20/24 on the same switch VLAN, then open https://192.168.50.10:8006. You can test that local IP without DNS or a gateway. If the browser still times out, check systemctl status pveproxy --no-pager and ss -lnt 'sport = :8006' at the Proxmox console to see whether the HTTPS service is running and listening. Proxmox pveproxy manual

OpenAI Codex assisted with drafting this reply.