Install Promox VE on Cisco UCS Blade

tikerbell

New Member
Feb 12, 2026
4
0
1
Has anyone installed Proxmox VE on a Cisco UCS blade? I’d like to try it, but I’m not sure where to start. Do I need to configure a custom profile, or can I use the existing Linux profile for the server where Proxmox VE will be installed? Does the network require any special configuration on the FI side? Thanks you
 
If this is managed by UCS Manager, I’d start with your Linux profile. Check that the boot policy can start the Proxmox ISO from virtual media and then boot the disk or SAN LUN you plan to install to. If that profile is assigned to another blade, create a separate one from the same template for this test. Cisco boot policy guide

On the FI side, start with the vNIC you’ll use for Proxmox management. Make sure the management VLAN is assigned to that vNIC and carried on its FI uplink and the upstream trunk. If the installer will use untagged management, set that VLAN as native on the vNIC. When you boot the ISO, check that the installer sees both your intended disk and that NIC before proceeding. Cisco UCS blade networking