Install problem

Ecoll

Active Member
Jan 31, 2019
8
0
41
46
Hi guys.

I have a problem with an installation

I have three servers at my cluster
Dell C2100 main cluster
IBM x3650m3 slave a Dell R210 II

I have a problem with the R210
the R210 have a software raid Perc S100, I have two ssds and I need raid1.
I tried to configure an array with perc but proxmox rebuilds both ssds but not the array.
I tried to do the table with ZFS Raid1. ok successfully install, but when I add it on the cluster, my local-lvm goes down. Gray icon with question mark (label: state: unknown).
In the status, I see active: no.

How can I do, would you have an idea?

thank you
 
I tried to do the table with ZFS Raid1. ok successfully install, but when I add it on the cluster, my local-lvm goes down
If you install on ZFS you have no local-lvm. you have ZFS.
see
https://pve.proxmox.com/wiki/Storage

Also, Raid cards and ZFS are known to not work proper together
So this is not supported and not recommended.