Hello everybody,
I'm new to the forum!
I'm asking for help with a problem I can't solve: I apologize if it's already been discussed but I couldn't find an answer by searching the various threads.
I just installed ProxMox VE 7.2 on my old HP ProLiant Microserver Gen 8. Everything works quite well, I also managed to enable the AMS Agentless Management Service which didn't work anymore with this new installation.
The problem that tortures me the most now is that I have a very low transfer rate: the controller is set to AHCI, I use a Samsung EVO 860 SSD on a 6Gb/sec bay but I have a maximum of 11.5Mb/sec speed. Is there any particular setting for this Microserver gen 8 to be done on ProxMox or in the BIOS?
I would like to have a "normal" speed
Thanks to those who will help me!
Zippi
I'm new to the forum!
I'm asking for help with a problem I can't solve: I apologize if it's already been discussed but I couldn't find an answer by searching the various threads.
I just installed ProxMox VE 7.2 on my old HP ProLiant Microserver Gen 8. Everything works quite well, I also managed to enable the AMS Agentless Management Service which didn't work anymore with this new installation.
The problem that tortures me the most now is that I have a very low transfer rate: the controller is set to AHCI, I use a Samsung EVO 860 SSD on a 6Gb/sec bay but I have a maximum of 11.5Mb/sec speed. Is there any particular setting for this Microserver gen 8 to be done on ProxMox or in the BIOS?
I would like to have a "normal" speed
Thanks to those who will help me!
Zippi