HP DL380 Gen 8 HBA not seen

[300cpilot]

I have two servers I am trying to get going but Proxmox does not display the drives attached to the HBAs. They show up fine in the bios and in windows. They each have 2 P420i's sas controllers, each with a single disk tray and 12 drives. Anyone know how to get these seen in Proxmox?

Thank you

 

[Vladimir Bulgaru]

The subject was previously addressed here: https://forum.proxmox.com/threads/p420i-in-hba-mode-no-boot.56195/#post-258873
Here is an article that might help you, but keep in mind that the solution is not the prettiest: https://www.reddit.com/r/homelab/comments/ap9usf/proxmoxzfs_installed_on_hp_dl360p/

 

[300cpilot]

I had seen this post, but my issue is not booting. I have 2 drives on the internal sas controller and Proxmox boots fine. Just when I go to build a new partition it will not see the drives in the disk tray.

 

[300cpilot]

I got it to finally see the drives. When I booted up and loaded proxmox from a new 6 version boot drive it found them.