HowTo use crossover connection for sync

[xrisse]

Hi,

sorry for my bad english - but i will try ;-)

i try to setup a PVE Cluster with an extra net for sync. I installed the two nodes by using the lan connection on eth0. after that, i configured eth1 (crosslink) on both nodes. but i'm not able to tell pveca to use the ip adress from eth1.
after trying around, i edited the config /etc/pve/cluster.conf and replaced the ips, but pveca will only accept eth ip on eth0.

any ideas?

 

[xrisse]

okay, i did it!
the /etc/network/interface was the right place. just build a second bridge (vmbr1) for the virtual machines and use the first bridge (vmbr0) for the clusternodes ;-)